|
|
 |
Grout Cleaning
| CLEANING GROUT: (Daily-Weekly) |
Product: Ceramiclean®
- Remove all abrasive debris from the floor surface.
- Mix 1-2 ounces of Ceramiclean per gallon of warm water.
- With a clean bucket and clean rayon or sponge mop, apply the Ceramiclean to the surface.
- Let the solution dry.
- Rinsing is only required for heavily soiled surfaces
|
| INTENSIVE CLEANING: (As Needed) |
Product: Stone Quest®
- Be sure the surface is free from loose debris and sediment.
- CLEANING DILUTION RATIOS:
- Light soil (2 ounces to 1 gallon of warm water)
- Medium soil (6 ounces to 1 gallon of warm water)
- Heavy soil (10 ounces to 1 gallon of warm water)
- Dilute STONE QUEST accordingly.
- Apply solution with a clean rayon mop or sponge mop.
- Let solution set for one minute.
(On polished marble or limestone let it set for a maximum of one minute.)
- Pick up solution with a mop or wet/dry vacuum.
- Lightly rinse with MARBALEX using a clean rayon mop or sponge mop.
|
| SEALING GROUT: (Every 1-3 years) |
Product: Grout Lock™
- Allow newly applied grout to cure overnight before applying sealer.
- Clean existing grout thoroughly before sealing.
- Test in an inconspicuous place for compatibility and satisfactory seal by seeing if water beads on the surface.
- SHAKE CAN WELL BEFORE USING.
- Invert can and point nozzle away from you; aim it at the grout line from a height of 10-15 inches.
- Press the nozzle and spray along the grout line, avoiding excess sealer that may result in pooling or residue.
- If pooling occurs, it is best to remove with a cloth while wet. (A cloth dampened with warm water will easily wipe up residue when it is dried).
- Apply a second coat after 30 minutes for best protection.
- At least one hour after sealing, apply a drop of water to the grout. If it does not bead up and is absorbed, another coat should be applied.
* The floor may be walked on when dried to the touch and full cure is achieved in 24 hours.
* Depending on traffic and wear, sealer may need to be reapplied after 1-3 years.
|
| RESTORING GROUT COLOR: (As Needed) |
Product: Grout Ink™
- Ensure surface is free from grease, dirt and other contaminants.
- Shake well with cap on before use. Remove cap, and then press pen down vertically for a minute until you see the ink starting to flow.
- Apply two (2) coats an hour apart.
- Replace cap when not in use.
* If grout is dirty, clean with SCI's Ceramiclean® before using the Grout Ink.
* Note: Ink colors may appear slightly different from the color of the pen caps.
|
|
|
|
|
|
